High Reliable Latest Enameled Wire Stripping Machine

FLM-DNB-006B Enameled Wire Stripping Machine

Product Introduction

The FLM-DNB-006B high-performance enameled wire stripping machine is a newly developed product. It is equipped with four hard tungsten steel alloy bars, adopting center-oriented cutting design with adjustable taper. It features exclusive designs for easy wire arrangement and rapid adjustment.

Combining convenient disassembly, flexible adjustment and detachable safety protective cover, this machine fully solves users’ pain points during enamel wire processing. It has won wide recognition and positive feedback from global customers after market launch.

Compared with the traditional FLM-DNB-006B model, the DNB-6B greatly boosts working efficiency and dramatically extends blade service life. It perfectly solves two common industry problems: incomplete stripping caused by bent wires and frequent blade jamming from enamel residue. It is a reliable, safe and ideal solution for enamel wire stripping.

This stripper fits wire gauges from 0.35mm to 5mm (custom enlarged models available). It thoroughly removes tough insulating varnish, enamel coating, ML film, Isonel film and other insulation layers without damaging copper wire cores.

It is especially suitable for stripping enamel all the way down to the coil base. Equipped with a stripping length stop device, it can precisely control stripping length. It delivers fast, safe stripping operations under low-pollution working conditions.

Technical Specifications

Model	FLM-DNB-006B	Applicable Wire Diameter	0.35 – 5mm (Custom enlarged model available)
Overall Dimension	280 × 200 × 150 mm	Rated Voltage	220v/50Hz
Motor Power	120w	Rotation Speed	2800r/min
Machine Weight	5.5kg	Blade Material	Hard Tungsten Steel Alloy
Stripping Length	4 – 50mm (Custom extended version available)	Brand	Freeman

Step-by-Step Operation Guide of Enameled Wire Stripping Machine

A. Power Connection

Plug the machine into a standard 220V power supply socket.

B. Pre-adjustment of Blades

Remove the safety cover of the blade assembly. Adjust the cutting opening according to your target wire diameter, then loosen the hex socket head cap screws used to fix the blade and positioning block.

C. Fine-tune Cutting Opening

Rotate the adjusting nut to resize the cutting opening: turn clockwise to narrow the gap, counterclockwise to widen it.

First set the opening slightly larger than the wire diameter;
Clamp the wire head, hold the enameled wire steadily and slowly turn the adjusting nut until the blades produce slight friction against the wire surface;
Fully lock all fixing screws after calibration.

D. Limit Pin Setup

Adjust and lock the limit pin, then reinstall the safety protective cover.

E. Start the Motor

Press the power switch to activate the motor.

F. Enamel Stripping Operation

Straighten the enameled wire, feed it flat into the feed inlet, and the machine will automatically strip the insulation layer.

Core Product Advantages

High Wear-resistant Tungsten Steel Blades Four hard tungsten steel alloy cutters extend service life many times over traditional blades, reducing replacement frequency and production cost.
Solves Classic Industry Troubles Eliminates incomplete stripping on bent wires and frequent enamel residue jamming on cutting heads, greatly lowering scrap rate.
Precise Length Control Built-in stripping length stop device allows accurate, repeatable stripping length for standardized coil production.
Flexible Customization Options Support customized enlarged wire range and extended stripping length to meet special production demands.
Safe & User-friendly Design Detachable transparent safety cover protects operators; fast-adjustment nut structure shortens wire model switching time.
Lightweight & Compact Structure Only 5.5kg with small footprint, easy to move and place on workbenches of coil winding workshops.